Dolby Laboratories CP650 Installation Manual Page 16

  • Download
  • Add to my manuals
  • Print
  • Page
    / 184
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 15
Dolby
®
Model CP650 Installation Manual Introduction
1-4
Microphone: Balanced input for Auditorium Assist microphone, PA mic, or B-chain
alignment mic (or multiplexer), 15 V phantom power switchable via front-panel DIP
switch; rear-panel XLR and front-panel 9-pin D-connector
AES/EBU digital inputs: Accommodate stereo PCM audio at 48, 44.1, or 32 kHz,
also accept Dolby Digital bitstreams; input via 25-pin D-connector with optional
adapter boards (Cat. Nos. 790 or 778)
110 ±20%, balanced (equipped with Cat. No. 778, four inputs), or
75 ±20%, single-ended (equipped with Cat. No. 790, four inputs)
Signal Outputs
Balanced, output impedance: 100 (load >600)
Maximum level: +26 dBu (15.5 V), balanced loads; +20 dBu (7.75 V), unbalanced
loads
Dolby level output adjust range: –31 to –12 dBu (20–780 mV)
Other Connections
Cat. No. 779 remote control unit and Cat. No. 771 remote fader connector (terminals
for stripped wires)
Connectors (front and rear) for external PC control and setup, RS-232C
(9-pin D-connector)
Hearing-impaired output: Center-weighted sum of L, R, and C; output
impedance 100, output level 200 mV fixed; unbalanced (RCA-type phono
connector)
Automation connector for controlling and indicating format, fader select, and mute;
interface similar to Model CP65
Connector for Ethernet link, RJ-45
Dolby Decoding
5.1 channels: Dolby Digital and Dolby Digital Surround EX
Four channels: Dolby A-type
Two channels: Dolby SR
Dolby Pro Logic
®
Page view 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 183 184

Comments to this Manuals

No comments