Dolby
®
Model CP650 Installation Manual Accessories
8-3
The wire to the CP650 must run from the connection point on the circuit board
without touching any circuit-board components.
• If the remote control will be mounted in a console or on a wall, we recommend
placing the hole in the bottom of the housing.
• If the remote control will stand alone, we recommend placing the hole in the side
of the housing.
• If you must put the hole in the top of the housing, place the hole in either of the
locations shown in Figure 8-2 to ensure that the wire has sufficient clearance.
38 mm
(1.5”)
38 mm
(1.5”)
19 mm
(.75”)
Center line
Caution: Do not drill holes in this area [top, sides and bottom].
Rear
Front
Top View
Figure 8–2 Location to Drill Wiring Hole
Caution: Do not drill in the front one-third of the housing (the shaded area in the
figure) on any side, or the circuit board will obstruct the opening.
8.2.3 Connect to the Circuit Board
Thread the interface wire through the hole you made. The J1 interface connector is in
the upper left-hand corner of the circuit board. Connect the wire to the J1 interface
connector as shown below.
Cat. No. 779
J1 interface connection to CP650
GND
DATA
V
Figure 8–3 Remote-Control Circuit-Board Connector
Comments to this Manuals