Dolby Laboratories CP500 Specifications Page 30
- Page / 154
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
3-13
3.7 Power On
Connect the bypass power module to the CP500 and plug it into AC mains. The
unit is shipped with the POWER/BYPASS switch set to BYPASS. The front panel
BYPASS LED should light.
Open the front panel and confirm that one of the Projector Select LEDs is on.
Projector 1 or Projector 2 is selected by Jumper J2 on the Cat. No. 661 (See
manual section 3.4).
Connect the main power cable. Then, push the Bypass/Power button to turn on the
CP500.
When power is first applied, the first
screen that appears displays the revision
level of the software. Next, a brief
"Loading System" message is displayed.
In a few seconds, the Current Format
screen appears. This is the normal screen
that the projectionist or any other
operator would see and the only screen
they will need to see for ordinary
purposes.
Run quick checks to confirm that:
• Rotating the front panel knob changes the numbers displayed next to it.
• Pushing the MUTE button causes the MUTE LED to flash.
• Pushing any of the buttons on each side of the display causes the mute LED to
go off and the LED next to the button pushed to go on (except buttons next to
" " on the display).
- Film-Tech 1
- Model CP500 2
- Model CP500 3
- TABLE OF CONTENTS 4
- 1.1 About the Dolby CP500 10
- 1.3 About This Manual 11
- 1.4 Specifications 12
- 1.5 Regulatory Notices 14
- SECTION 2 16
- EQUIPMENT REQUIRED 16
- TEST FILM 17
- 3.1.2 While playing the film: 18
- 3.2 Mount the CP500 19
- 3.3 Connect the CP500 19
- (Models CP500-D, and -70) 20
- Figure 3 - 2 22
- Figure 3 - 3 22
- 3.4 Check and Set Jumpers 23
- CAT. NO. 683 25
- Appendix B, Cat. No. 683 26
- Model CP500-D 27
- Model CP500-D/300 28
- Model CP500-SR 28
- Model CP500-70 28
- 3.6 Bypass Power Wiring 29
- 3.7 Power On 30
- 4.1 The CP500 Front Panel 32
- 4.2 System Password 35
- 4.3 Aligning the B-Chain 36
- 5.1 Check Theater Equipment 38
- 5.2.2 Screen Channels 39
- B-Chain Alignment 40
- 5.3 Room Equalization 41
- “85 dBC” 44
- Reference 47
- Response 47
- CAT. NO. 682 52
- Cat. No. 682 card 53
- 6.1 Aligning the A-Chain 54
- LAMP VOLTAGE DC ADJUSTMENT 56
- OSCILLOSCOPE TRACES 60
- CAT. NO. 661 61
- P1, Left 62
- 7.1 Mechanical Alignment 66
- 2.7 to 5 volts 67
- Voltage Adjust 68
- 7.6 Optical Alignment 69
- Figure 7- 5 70
- 7.8 Film Threading 71
- 7.9 Cat. No. 673 72
- 7.11 Format Control 72
- Allowable Source Formats 75
- Allowable Target Formats 75
- How It Works 75
- Assigning Source Formats 76
- Assigning Target Formats 77
- Figure 7- 8 78
- 7.13.2 Print Cleanliness 79
- 7.13.3 Adjustments 79
- SECTION 8 80
- FINAL ADJUSTMENTS 80
- 8.2.1 Static 82
- 8.2.2 Dynamic 83
- 8.2.3 Typical Settings 83
- Width (feet) 84
- Width (meters) 84
- 8.4 Bypass Adjustments 85
- Position J900 to 86
- REMEMBER 87
- Format 04 Dolby Stereo 89
- Adjustments 90
- 8.5 About Non-sync 91
- 8.6 Mute Speed Adjustment 92
- Figure 9 - 1 93
- CAT. NO. 689 REMOTE 94
- 9.1.3 Auditorium Fader 95
- 9.2.1 Operation 96
- 9.2.2 Components 98
- 10.1 During the Show 99
- Surround Speakers 101
- Electronic Crossover: 101
- 10.2 Between Shows 102
- WARNING: 104
- 10.3 Troubleshooting Chart 105
- NO SOUND AT ALL 106
- NO SOUND IN SOME 107
- FADER PROBLEMS 108
- CONTROL PROBLEMS 108
- RUMBLES, WHISTLES 109
- HUM etc. IN SOUND 109
- TROUBLE IN ONE OR 110
- MORE CHANNELS 110
- CHANGEOVER AND 113
- CONTROL TROUBLES 113
- APPENDIX A 115
- ADVANCED OPERATIONS 115
- Cancel OK 116
- A.2 Saving System Settings 119
- Saving System Settings 120
- A.2.2 Using Load500 Software 125
- Connect to Load500 127
- Menu Cancel OK 130
- B.1 Description and Features 131
- B.2 Installation 131
- B.3 Alignment 132
- B.4 Special Applications 134
- B.5 Headers Available 135
- B.6 Jumpers and Headers 136
- APPENDIX C 138
- 9. Mic. Input Connector: 140
- System Setup Menu Tree 144
- Signal Block Diagram 144
- Basic Functions 145
- Auxiliary Data Channel 147
- Optical Sound 149
- Magnetic Sound 150
- Dolby Gets Involved 151
- The Next Step: Dolby SR 152
- And Now - Dolby Digital 152
- About Dolby AC-3 153
- Making Films Sound Better 153
Related products and manuals for Recording Equipment Dolby Laboratories CP500
(123 pages)© 2020, manymanuals.com. All rights reserved. | 0.894 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals