Dolby Laboratories CP650 Installation Manual Page 47
- Page / 166
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Dolby
®
CP650 Installation Manual Front-Panel and Alignment Overview
3-7
3.2 The Setup Control Panel
The setup control panel is located behind the front-panel access door.
Mic Bypass
Video
Clamp RTA1 RTA2
1
1
2
2
3
3
7
7
4
4
5
5
6
6
8
8
SIGNAL
PRESENT
MAIN
HF
Lt
Rt
Lt Rt
SwLCRLsRs
SERIAL DATA MIC MUX
MIC input level
control
BYPASS output level
control
LEDsindicate presence
of an opticalsoundtrack
signal.
Alaptop PC can be
connected to this RS-232
data port. Windows-based
set-up software is available
for aligning the CP650. This
connector is duplicated on
the rear panel of the CP650.
Connect a microphone
multip
lexer here or to the rear
panel MIC INPUT connector.
Testpoints used for
connecting an
oscilloscope to
displayCP650 RTA
Channelsignal output testpoints
Testpoints used for
alignment of the digital
soundhead.
Screw for removing the
plastic front panel.
Wakeup
projector 1
Wakeup
projector 2
Mic Phantom Power ON
Load baseline software
during power-up
Setup Mode
Dip Switch
Figure 3-8 Setup Control Panel
Mic Input Level Control
This ten-turn potentiometer has an end-to-end range of 46 dB. It is shipped from the
factory set to minimum.
Bypass Output Level Controls (not active on CP650DC models)
These two potentiometers, located on the Cat. No. 772B card, set the CP650 output
level when the unit switches to bypass operation. The HF control is used if the CP650
is equipped with a Cat. No. 791 Crossover Card. Earlier units used the Cat. No. 772
card with a single potentiometer.
- Digital Cinema Processor 1
- Installation Manual 1
- Dolby Laboratories, Inc 2
- Table of Contents 3
- CP650 Installation Manual 4
- List of Figures 6
- List of Tables 7
- Regulatory Notices 8
- CP650 Installation Manual 11
- Chapter 1 13
- Introduction 13
- Dolby Digital 18
- Surround EX mode 18
- 1.4 Specifications 19
- 2.1 Check Main Fuse 21
- 2.3 Mount the CP650 22
- 2.5 Connect the CP650 23
- 2.5.2 Remote Controls 24
- 2.5.5 Digital Audio Sources 28
- For Cat.No. 778 29
- For Cat.No. 794 29
- CP650 INSTALLATION WIRING 33
- INPUT AND CONTROL CONNECTIONS 33
- AUDIO OUTPUT CONNECTIONS 35
- CP650DCXO INSTALLATION WIRING 38
- Chapter 3 41
- 3 1/3 db 45
- 3.2 The Setup Control Panel 47
- Chapter 4 51
- B-Chain Alignment 51
- 4.2 Microphone Placement 52
- 4.3 Initial Setup 53
- OK to save this setting 54
- Mic Level Too Low 55
- Proceeding 55
- Uncalibrated 55
- 4.5.1 Main Channels 56
- 4.5.2 Subwoofer Channel 57
- Cat. No. 791 58
- Screen Loss 58
- Filter Jumpers 58
- Crossover Mode 59
- >3 Way 59
- Le / Re Channels 59
- Disabled 59
- OK to save 62
- 4.7 Room Equalization 63
- 4.7.2 Setting Coarse EQ 64
- 4.7.3 Setting Fine EQ 65
- 4.7.4 The EQ Assist Feature 66
- Digital Subwoofer 68
- >Level: xx 68
- Polarity: Normal 68
- Center Noise: Off 68
- OK to save the selection 69
- 123 7456 8 70
- Chapter 5 71
- A-Chain Alignment 71
- 5.1 Projector Checkup 72
- 5.3 Dolby Level Set 74
- 5.3.2 Manual 75
- 5.5 Cell Alignment Check 76
- 5.6 Cell Wiring Check 77
- 5.7 Azimuth Check 77
- 5.8 Focus Check 78
- 5.9.1 Auto Slit-Loss EQ 79
- 5.9.2 Manual Slit-Loss EQ 79
- OK to save the settings 80
- Chapter 6 81
- Digital Soundheads 81
- 6.3 Focus Adjustment 82
- 6.4.1 Cat. No. 702 Reader 83
- 6.4.2 Cat. No. 701 Reader 84
- Chapter 7 85
- Final Adjustments 85
- OK to save the setting 86
- Digital Surround 88
- > xxx mSec 88
- 7.8 Mono Level Trim 92
- 7.9 Mono EQ Adjustment 92
- Front-Panel Buttons 92
- Button Presets 93
- Button 01 93
- Fader: 6.5 93
- >Delay: 0—170 mSec 93
- 7.13 Reversion Mode 94
- 7.15 Noise Gating 94
- 7.16.3 Fail Parameters 97
- L M1 0 99
- 7.17 Dialogue Normalization 100
- 7.18 Network Configuration 100
- 7.19 Clock Set 101
- 7.20 Date Set 101
- Chapter 8 103
- Accessories 103
- 8.1.1 Remove the Housing 104
- Top View 105
- 8.1.5 Assemble the Unit 106
- 8.1.6 Connect to the CP650 107
- Chapter 9 109
- 9.3 CP650 Troubleshooting 110
- Bypass Fuse 111
- 9.3.3 The Event Log 112
- 9.3.4 Troubleshooting Chart 112
- NO SOUND AT ALL 113
- NO SOUND IN SOME 114
- FORMATS 114
- FADER PROBLEMS 115
- CONTROL PROBLEMS 115
- RUMBLES, WHISTLES 116
- HUM IN SOUND 116
- TROUBLE IN ONE OR 117
- MORE CHANNELS 117
- CHANGEOVER AND 120
- CONTROL TROUBLES 120
- CP650 POWER SUPPLY WIRING 122
- CAT.NO.776-5 (GOLD COVER) 122
- CAT.NO.776-2 (GOLD COVER) 124
- Cat. No. 702 Exploded View 125
- Cat. No. 702 REAR VIEW 126
- F11504A_2.CDR 127
- Cat. No. 700 / 701 REAR VIEW 128
- Appendix A 129
- Software Operations 129
- A.2 Updating CP650 Software 130
- Appendix B 133
- Rear-Panel Connectors 133
- B.2 Input Connectors 136
- B.3 I/O Connectors 140
- Appendix C 143
- Format Descriptions 143
- C.2 Format Definitions 144
- Cat. No. 778 AES1 153
- Appendix D 155
- External Control 155
- Key Range of Values Notes 156
- Serial Data 157
- Remotes and Aud. Fader 158
- Appendix E 161
- Setup and User Menus 161
- + = 161
- = Bypass/Normal toggle 163
- (Cat. No. 778 only) 164
- E.2 CP650 User Menu 165
- DIP switch 6 Down 165
Related products and manuals for Recording Equipment Dolby Laboratories CP650
(112 pages)
(154 pages)© 2020, manymanuals.com. All rights reserved. | 0.196 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals