Dolby Laboratories CP650 Installation Manual Page 100
- Page / 166
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Dolby
®
CP650 Installation Manual Final Adjustments
7-16
Dialogue Normalization
> Enabled
123 7456 8
7.17 Dialogue Normalization
This feature is normally set to Disabled, and affects Dolby Digital bitstreams from
consumer devices such as DVD and terrestrial/satellite broadcast sources.
With dialogue normalization enabled, the overall playback level is set in relation to
the Center channel dialogue information. This level is determined and set during the
encoding process, and is carried by metadata embedded in the Dolby Digital
bitstream.
1. Press to move to the Dialogue Normalization
screen, then rotate the front-panel knob to switch between
Enabled and Disabled.
2. Press OK to save the setting.
7.18 Network Configuration
A CP650 can be controlled via an Ethernet-based network using a PC connected to
the CP650 through a hub or switch, or directly, using a network crossover cable.
See Appendix D.1, Control via Serial Port for further information.
Default network settings:
software version 2.3.5.2 and later
Default network settings:
software version 2.3.4.4 and earlier
IP address—192.168.x.132
(x=auditorium number)
IP address—192.168.99.200
Address mask—255.255.255.128 Address mask—255.255.255.0
Gateway address—192.168.x.129 Gateway address—192.168.99.1
System name—Dolby_cp650
Use the Network Parameters menu item to set up the CP650 for network control:
1. Switch the CP650 into Setup mode by sliding DIP switch 6 to
the up position.
2. Press multiple times (or press and hold the button while
rotating the front-panel fader knob) to move to the Network
Parameters menu.
3. The default local IP address is shown in this example. To change
the first octet (0 to 255), rotate the front-panel knob.
4. Move the cursor to the next octet by pressing and holding
while rotating the front-panel fader knob. Rotate the front-panel
knob to set the number and continue to the next octet.
5. Press to move to the next network parameter, and set the
values using the same procedure as above.
6. Press OK to save your settings.
Network Parameters
Local IP address:
192.168. 99.200
Network Parameters
Local IP address:
192.168. 99.200
Network Parameters
Local IP address:
192.168. 99.200
Network Parameters
Address Mask:
192.168. 99. 1
- Digital Cinema Processor 1
- Installation Manual 1
- Dolby Laboratories, Inc 2
- Table of Contents 3
- CP650 Installation Manual 4
- List of Figures 6
- List of Tables 7
- Regulatory Notices 8
- CP650 Installation Manual 11
- Chapter 1 13
- Introduction 13
- Dolby Digital 18
- Surround EX mode 18
- 1.4 Specifications 19
- 2.1 Check Main Fuse 21
- 2.3 Mount the CP650 22
- 2.5 Connect the CP650 23
- 2.5.2 Remote Controls 24
- 2.5.5 Digital Audio Sources 28
- For Cat.No. 778 29
- For Cat.No. 794 29
- CP650 INSTALLATION WIRING 33
- INPUT AND CONTROL CONNECTIONS 33
- AUDIO OUTPUT CONNECTIONS 35
- CP650DCXO INSTALLATION WIRING 38
- Chapter 3 41
- 3 1/3 db 45
- 3.2 The Setup Control Panel 47
- Chapter 4 51
- B-Chain Alignment 51
- 4.2 Microphone Placement 52
- 4.3 Initial Setup 53
- OK to save this setting 54
- Mic Level Too Low 55
- Proceeding 55
- Uncalibrated 55
- 4.5.1 Main Channels 56
- 4.5.2 Subwoofer Channel 57
- Cat. No. 791 58
- Screen Loss 58
- Filter Jumpers 58
- Crossover Mode 59
- >3 Way 59
- Le / Re Channels 59
- Disabled 59
- OK to save 62
- 4.7 Room Equalization 63
- 4.7.2 Setting Coarse EQ 64
- 4.7.3 Setting Fine EQ 65
- 4.7.4 The EQ Assist Feature 66
- Digital Subwoofer 68
- >Level: xx 68
- Polarity: Normal 68
- Center Noise: Off 68
- OK to save the selection 69
- 123 7456 8 70
- Chapter 5 71
- A-Chain Alignment 71
- 5.1 Projector Checkup 72
- 5.3 Dolby Level Set 74
- 5.3.2 Manual 75
- 5.5 Cell Alignment Check 76
- 5.6 Cell Wiring Check 77
- 5.7 Azimuth Check 77
- 5.8 Focus Check 78
- 5.9.1 Auto Slit-Loss EQ 79
- 5.9.2 Manual Slit-Loss EQ 79
- OK to save the settings 80
- Chapter 6 81
- Digital Soundheads 81
- 6.3 Focus Adjustment 82
- 6.4.1 Cat. No. 702 Reader 83
- 6.4.2 Cat. No. 701 Reader 84
- Chapter 7 85
- Final Adjustments 85
- OK to save the setting 86
- Digital Surround 88
- > xxx mSec 88
- 7.8 Mono Level Trim 92
- 7.9 Mono EQ Adjustment 92
- Front-Panel Buttons 92
- Button Presets 93
- Button 01 93
- Fader: 6.5 93
- >Delay: 0—170 mSec 93
- 7.13 Reversion Mode 94
- 7.15 Noise Gating 94
- 7.16.3 Fail Parameters 97
- L M1 0 99
- 7.17 Dialogue Normalization 100
- 7.18 Network Configuration 100
- 7.19 Clock Set 101
- 7.20 Date Set 101
- Chapter 8 103
- Accessories 103
- 8.1.1 Remove the Housing 104
- Top View 105
- 8.1.5 Assemble the Unit 106
- 8.1.6 Connect to the CP650 107
- Chapter 9 109
- 9.3 CP650 Troubleshooting 110
- Bypass Fuse 111
- 9.3.3 The Event Log 112
- 9.3.4 Troubleshooting Chart 112
- NO SOUND AT ALL 113
- NO SOUND IN SOME 114
- FORMATS 114
- FADER PROBLEMS 115
- CONTROL PROBLEMS 115
- RUMBLES, WHISTLES 116
- HUM IN SOUND 116
- TROUBLE IN ONE OR 117
- MORE CHANNELS 117
- CHANGEOVER AND 120
- CONTROL TROUBLES 120
- CP650 POWER SUPPLY WIRING 122
- CAT.NO.776-5 (GOLD COVER) 122
- CAT.NO.776-2 (GOLD COVER) 124
- Cat. No. 702 Exploded View 125
- Cat. No. 702 REAR VIEW 126
- F11504A_2.CDR 127
- Cat. No. 700 / 701 REAR VIEW 128
- Appendix A 129
- Software Operations 129
- A.2 Updating CP650 Software 130
- Appendix B 133
- Rear-Panel Connectors 133
- B.2 Input Connectors 136
- B.3 I/O Connectors 140
- Appendix C 143
- Format Descriptions 143
- C.2 Format Definitions 144
- Cat. No. 778 AES1 153
- Appendix D 155
- External Control 155
- Key Range of Values Notes 156
- Serial Data 157
- Remotes and Aud. Fader 158
- Appendix E 161
- Setup and User Menus 161
- + = 161
- = Bypass/Normal toggle 163
- (Cat. No. 778 only) 164
- E.2 CP650 User Menu 165
- DIP switch 6 Down 165
Related products and manuals for Recording Equipment Dolby Laboratories CP650
(112 pages)
(154 pages)© 2020, manymanuals.com. All rights reserved. | 0.414 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals