Dolby Laboratories CP500-300 Specifications Page 34
- Page / 153
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
4-4
A manual bypass push-button is located inside the front panel on the right hand side
of the unit.
4.2 System Password
Many of the CP500 alignment functions can be protected from unauthorized access
be using a system password (any four numbers). A password can be stored after the
system is aligned in order to block any changes to the B-chain alignment, level
settings, or time delays. Knowledge of this password would be required to enter
these CP500 menus. The CP500 is shipped with no system password. The number
stored in CP500 memory is "0000". This allows access to all alignment functions.
The following procedure should be used to set or change the system password.
MENU
Press the MENU key.
FORMATS
Menu Cancel OK
Exit
The Menu Selections screen will be
displayed.
Press Alignment (SK2).
FORMATS
Menu Cancel OK
Exit
The System Alignment screen will
appear. Press Set System Password
(SK8).
NOTE
:
If a system password has already been
stored in memory, then the screen below will
appear.
Rotate the front panel knob to select the
digit you wish to set, then press and hold
soft-key SK4, "1234", while rotating the
front panel knob to set the desired
number. Repeat this process for any of
the four password digits you wish to set.
OK
Press the OK key to store the new
password.
- Model CP500 1
- Model CP500 2
- TABLE OF CONTENTS 3
- 1.1 About the Dolby CP500 9
- 1.3 About This Manual 10
- 1.4 Specifications 11
- 1.5 Regulatory Notices 13
- SECTION 2 15
- EQUIPMENT REQUIRED 15
- TEST FILM 16
- 3.1.2 While playing the film: 17
- 3.2 Mount the CP500 18
- 3.3 Connect the CP500 18
- (Models CP500-D, and -70) 19
- Figure 3 - 2 21
- Figure 3 - 3 21
- 3.4 Check and Set Jumpers 22
- 1.9 mSEC 1.9 mSEC 1.9 mSEC 24
- Appendix B, Cat. No. 683 25
- Model CP500-D 26
- Model CP500-D/300 27
- Model CP500-SR 27
- Model CP500-70 27
- 3.6 Bypass Power Wiring 28
- 3.7 Power On 29
- 4.1 The CP500 Front Panel 31
- 4.2 System Password 34
- 4.3 Aligning the B-Chain 35
- Amplifiers 37
- Air-conditioning 38
- B-Chain Alignment 39
- POWER AMPS 40
- “85 dBC” 43
- Cat. No. 682 card 52
- 6.1 Aligning the A-Chain 53
- LAMP VOLTAGE DC ADJUSTMENT 55
- OSCILLOSCOPE TRACES 59
- CAT. NO. 661 60
- P1, Left 61
- P1, Right 62
- Projector 1 64
- 7.1 Mechanical Alignment 65
- 7.3 Focus Adjustment 66
- Figure 7- 2 67
- Figure 7- 3 68
- Figure 7- 4 68
- CCD Circuit Board 68
- Figure 7- 5 69
- 7.8 Film Threading 70
- 7.9 Cat. No. 673 71
- 7.11 Format Control 71
- Allowable Source Formats 74
- Allowable Target Formats 74
- How It Works 74
- Assigning Source Formats 75
- Assigning Target Formats 76
- Figure 7- 8 77
- 7.13.2 Print Cleanliness 78
- 7.13.3 Adjustments 78
- SECTION 8 79
- FINAL ADJUSTMENTS 79
- 8.2.1 Static 81
- 8.2.2 Dynamic 82
- 8.2.3 Typical Settings 82
- Width (feet) 83
- Width (meters) 83
- 8.4 Bypass Adjustments 84
- REMEMBER 86
- Format 04 Dolby Stereo 88
- REMEMBER: 89
- Figure 8-2 90
- Figure 9 - 1 92
- CAT. NO. 689 REMOTE 93
- Selection 94
- 9.2.1 Operation 95
- 9.2.2 Components 97
- 10.1 During the Show 98
- Surround Speakers 100
- Electronic Crossover: 100
- 10.2 Between Shows 101
- WARNING: 103
- 10.3 Troubleshooting Chart 104
- NO SOUND AT ALL 105
- NO SOUND IN SOME 106
- FADER PROBLEMS 107
- CONTROL PROBLEMS 107
- RUMBLES, WHISTLES 108
- HUM etc. IN SOUND 108
- TROUBLE IN ONE OR 109
- MORE CHANNELS 109
- CHANGEOVER AND 112
- CONTROL TROUBLES 112
- APPENDIX A 114
- ADVANCED OPERATIONS 114
- Cancel OK 115
- Equipment Needed 118
- Saving System Settings 119
- Connect to Load500 124
- Menu Cancel OK 129
- B.1 Description and Features 130
- B.2 Installation 130
- B.3 Alignment 131
- B.4 Special Applications 133
- B.5 Headers Available 134
- B.6 Jumpers and Headers 135
- 1. Automation Connector: 137
- 2. Serial Data Connector: 137
- 3. Motor Start Connector: 137
- 9. Mic. Input Connector: 139
- System Setup Menu Tree 143
- Signal Block Diagram 143
- Basic Functions 144
- Auxiliary Data Channel 146
- Optical Sound 148
- Magnetic Sound 149
- Dolby Gets Involved 150
- The Next Step: Dolby SR 151
- And Now - Dolby Digital 151
- About Dolby AC-3 152
- Making Films Sound Better 152
Related products and manuals for Recording Equipment Dolby Laboratories CP500-300
(54 pages)© 2020, manymanuals.com. All rights reserved. | 0.828 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals