Dolby Laboratories ZE-200DVD Operations Instructions download pdf (Page 67)

Settings and Adjustments

Adjusting the speaker volume

1 While you stop playback, select “SPEAKER SETUP”

after pressing SET UP.

2 Select “TEST TONE” and set “TEST TONE” to “ON.”

You will hear the test tone from each speaker in

sequence.

3 From your listening position, select “BALANCE” or

“LEVEL” and adjust the value of “BALANCE” and

“LEVEL” using >/..

During this adjustment, the test tone is emitted from

both speakers simultaneously.

4 Select “TEST TONE” and set “TEST TONE” to “OFF”

to turn off the test tone.

Controlling the TV or the

AV Receiver (Amplifier)

with the Supplied Remote

If you adjust the remote signal, you can control your TV

with the supplied remote. Default setting is to control

Sony TVs with the g mark.

When you connect the player to a Sony AV receiver

(amplifier), you can also set the input of the receiver

(amplifier) to this player with the supplied remote.

Controlling TVs with the remote

1 Slide the TV/DISC EXPLORER/DVD switch to TV.

2 Hold down 1/u (POWER), and enter your TV’s

manufacturer’s code (see the table on the next

page) using the number buttons. Then release 1/u

(POWER).

Code numbers of controllable TVs

If more than one code number is listed, try entering them

one at a time until you find the one that works with your

TV.

Notes

• If you enter a new code number, the code number previously

entered will be erased.

• When you replace the batteries of the remote commander, the

code number may reset to 01 (Sony). Reset the appropriate code

number.

Number buttons

TV/DISC EXPLORER/

DVD switch

1/u (POWER)

123

789

A B C D ALL

DVD CD

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 83 84

Comments to this Manuals

No comments

Dolby Laboratories ZE-200DVD Operations Instructions Page 67

Comments to this Manuals

Related products and manuals for DVD players Dolby Laboratories ZE-200DVD